3/14/2024 0 Comments Versapro jump starterWhen I close the panel editor in Quick Designer, this is when VersaPro crashes. VersaPro mainly crashes when I have Quick Designer running editing a panel, while VersaPro is running in the back ground and connected to my PLC already logic equal. Of course when VersaPro crashes, I've always have to end task the "Cam Stop" service then re-start VersaPro so I don't get that "Can only run one instance of Cam Stop yada yada warning you get when you try and launch two copies of VersaPro. The only way for me to recover from this problem is to re-upload my program from the PLC back into my laptop, then VersaPro goes equal finally. After downloading either method above, I then do a verify to check and see if the version in the PLC is the same as my copy on my laptop and VersaPro shows that the copy is all EQUAL, but it won't go logic equal. If I clear the PLC memory and re-download my program, it still doesn't go equal. If I stop the PLC and do a store all to the PLC from laptop, it still doesn't go equal. I can only get my program to go equal again by doing a complete upload. When it does crash, I lose the "Logic Equal" when online. VersaPro crashes generally when I am online with a PLC. I am using VersaPro 2.04 and more and more VersaPro is crashing. So I am going to ask the question now because it's happening more frequent. I been having a life long Versa Pro problem that I've always just dealt with.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |